|
|
WEEKLY MAINTENANCE PROCEDURES |
Weekly Maintenance
A.
(Following Daily Step #8)
Using plunger, lower water level in toilet bowls below water line to allow HI-GENIC to
descale and dissolve water ring.
B.
Squirt HI-GENIC under the flushing rims of toilets
and urinals, then with the TOILET BOWL SWAB, spread bowl cleaner evenly, clean and flush.
C.
(Following Daily Step #13)
Spray T.E.T. #6 DISINFECTANT CLEANER solution under sinks, pipes, rear wall and base
molding.
D.
(Following Daily Step #16)
Scrub underneath sink with SCRUB SPONGE and wipe dry with paper towel. Leave base molding until you do the floor.
E.
(Following Daily Step #19)
Completely wipe stall partitions with SCRUB SPONGE saturated with T.E.T. #6 DISINFECTANT
CLEANER solution, wipe dry with paper towel.
F.
(Following Daily Step #20)
Using SCRUB SPONGE saturated with T.E.T. #6 DISINFECTANT CLEANER solution, clean both
sides of entry doors, door frame, metal plates and hinges.
Wipe dry with paper towel.
G. (Replaces
Daily Step #21)
Dilute T.E.T. #6 DISINFECTANT CLEANER 1:256 (1/2 oz. per gallon of water), mop solution on
the floor quite generously.
H.
Use DECK SCRUB BRUSH to clean base molding and hard
to get at areas.
NOTE: Base molding with heavy build-up will
require cleaning with a special material before this method will be effective. (Contact
your supervisor.)
I.
Rinse the floor with clear water to
remove dirty solution from floor. (When required, scrub floor with low-speed machine (blue scrub pad), or
DECK SCRUB BRUSH prior to mopping.)
J.
Saturate a clean mop with freshly diluted
(1:256) bucket of T.E.T. #6 DISINFECTANT CLEANER, wring dry and damp mop entire floor. |
|
|
|
|
